Speeco S401622PH - Manual (Page 10)

Page 8
STEP 4: Stand the beam (1) up on end. Two people may be needed for this step to ensure safety. Make sure that the
beam is stable and on a level surface. Remove the pivot pin (2) and clip pin (3) from the tank assembly. Roll the
tongue/tank assembly into position between the two tabs on the beam (1). Slide the pivot pin (2) through the
aligned holes and lock in place with the clip pin (3).
STEP 3: Attach the tongue assembly (5) to the tank assembly (1) using two 1/2” NC x 4-1/2” hex cap bolts (2), two 1/2”
lock washers (3) and two and two 1/2” hex nuts (4). Tighten.
ITEM NO. DESCRIPTION QTY.
1 Tank Assembly 1
2 1/2” NC x 4-1/2 Hex Bolt 2
3 1/2” Lock Washer 2
4 1/2” NC Hex Nut 2
5 Tongue Assembly 1
ITEM NO. DESCRIPTION QTY.
1 Beam Assembly 1
2 1/2”-3/4” R Clip Pin 1
3 Pivot Pin 1