Speeco S401233CA - Manual (Page 13)

ENGINE OIL RECOMMENDATIONS
For temperatures above 40 degrees F, use an SAE 30W oil. Using multigrade oil may increase oil consumption. Using SAE 30 oil below 40 degrees
F will result in hard starting and possible engine bore damage. For temperatures below 40 degrees F, use an SAE 10W-30 or SAE 5W-30 oil. Oil
capacity is approximately 5/8 quart (20 ounces; 0.6 liter).
STEP 2: After the hydraulic reservoir and the engine crankcase are filled with oil, start the engine. The hydraulic pump should prime itself. With
the engine running, move the hydraulic valve lever toward the wedge. This will cause the cylinder to extend and expel air. When the
cylinder is fully extended, retract it. Repeat this procedure several times. An erratic movement of the cylinder indicates that there is still
air in the system. More oil should then be added to bring the fluid level up to the “OK” range on the dipstick. Total hydraulic capacity for
the 22 ton model is 5 gallons.
STARTING INSTRUCTIONS
Refer also to the Operator’s Manual for your particular log splitter for engine operating and maintenance instructions.
1) Move throttle control to “FAST.”
2) Push primer bulb three (3) times.
NOTE: DO NOT USE PRIMER TO RESTART A WARM ENGINE AFTER A SHORT SHUTDOWN.
3) Grasp starter rope handle and pull out slowly until resistance is felt. Then pull rapidly with a full arm stroke.
NOTE: If engine fails to start after three (3) pulls, repeat instructions 2 and 3.
4) When engine starts, leave throttle control at “FAST.” The throttle must be in the “FAST” position for maximum performance.
5) To stop engine, move the throttle to “SLOW” and then to “STOP.”
OPERATING INSTRUCTIONS
WARNING: Be sure to read the IMPORTANT SAFETY INFORMATION at the beginning of this manual
before operating the log splitter.
Si no entiende ingles, se prefiere que busque alguien que interprete las instrucciones para usted.
STEP 1: Fill the tank reservoir with the recommended hydraulic oil. Fill the hydraulic tank with approximately 3.5 to 4 gallons of hydraulic oil.
HYDRAULIC OIL RECOMMENDATIONS
AW 46 hydraulic oil is recommended when oil is needed. Automatic transmisssion fluid can be substituted and should be used instead of hydraulic
oil when temperatures are below 32 degrees F. Use only clean oil and take care to prevent dirt from entering the hydraulic reservoir.
Page 11
IMPORTANT: This log splitter must be filled with hydraulic oil and engine oil before operation. Please follow the instructions below
for filling the hydraulic tank. Refer also to the engine owner’s manual for your particular log splitter for information on adding oil to the engine.
NOTICE: Do not start or run the engine before adding oil in the hydraulic reservoir and oil in the engine.
CAUTION: WHEN TIGHTENING THE BREATHER CAP ON THE TANK, POINT THE HOLE AWAY FROM
THE ENGINE ANDTHE OPERATOR ZONE.
CAUTION: IF THE TANK IS OVERFILLED, IT WILL TEND TO EXPEL OIL FROM THE BREATHER CAP
WHEN THE CYLINDER IS RETRACTED. CYCLE THE CYLINDER AGAIN UNTIL IT HAS A
CONSTANT SPEED INDICATING THAT ALL AIR HAS BEEN EXPELLED.
NOTE: The engine maximum governed speed is preset at the factory at 3600 RPM no load speed. When splitting wood, the throttle
should be set at the maximum speed to develop the horsepower required for the pump.