Speeco S401628BB User Manual
Page 11
4
Page 9
STEP 5: Connect the end of the 1/2” ID x 38” hydraulic pressure hose (1) coming from the fitting on the pump to the
fitting on the valve. See illustrations below.
STEP 6: Slide one hose clamp on the end of the 3/4” x 56” hydraulic return hose (2) that comes from the fitting on the
filter. Then connect the hose to the fitting on the valve. Tighten hose clamp. See illustrations below.
Area of
Detail
DETAIL A
SCALE 1:3
ITEM NO.
DESCRPTION
QTY.
1
1/2” X 38” Pressure Hose
1
2
3/4” x 56” Return Hose
1
3
Worm Gear Clamp
3
STEP 7: Attach the latch (3) to the bottom side of the beam as shown in the diagram using the two 1/2” x 1-1/4”
Grade 5 hex cap bolts (4), the two 1/2” lock washers (1) and the two 1/2” hex nuts (2). Lower the beam onto
the tongue. Position the latch assembly on the tongue and tighten hardware.
ITEM NO. DESCRIPTION
QTY.
1
1/2” Lock Washer
2
2
1/2” Hex Nut
2
3
Beam Lock
1
4
1/2” x 1-1/4” Bolt
2
Page 9