Speeco 401635BBCA User Manual
Page 11
STEP 5: Connect the end of the 1/2” ID x 38” hydraulic pressure hose (1) coming from the fitting on the pump to the
fitting on the valve . See illustrations below.
STEP 6: Slide one hose clamp (3) on the end of the 3/4” x 56” hydraulic return hose (2 ) that comes from the fitting on
the filter . Then connect the hose to the fitting on the valve . See illustrations below.
Area of
Detail
ITEM NO. PART NO.
DESCRPTION
QTY.
1
39027500
1/2” X 38” Pressure Hose
1
2
39027400
3/4” x 56” Return Hose
1
3
39031600
Worm Gear Clamp
3
STEP 7: Loosely attach the latch assembly (1) to the bottom side of the beam as shown in the diagram using the
two 1/2” x 1-1/4” GR 5 hex cap bolts (4), the two 1/2” lock washers (3) and the two 1/2” hex nuts (2). Lower
the beam onto the tongue. Center the latch assembly on the tongue and tighten hardware.
ITEM NO. PART NO.
DECSRIPTION
QTY.
1
40127500
Beam Lock
1
2
O/L
1/2” Hex Nut
2
3
O/L
1/2” Lock Washer
2
4
O/L
1/2” x 1-1/4” GR5 Hex Cap Bolt
2
Page 9