Speeco S241003C0 - Manual (Page 6)

1) Check the level of gear box lubricant after approximately one year of use. Check sooner if digger is used
frequently. Add a 10W-30 oil if the level is below the top of the gears. Do not overfill the gearbox.
2) Periodically check all nuts and bolts for tightness.
3) Periodically check that the air filter is not dirty. A dirty air filter may cause the auger to consume more fuel.
3) Periodically check the cutting blade and tip for wear and replace if necessary.
NOTE: Replacing worn blades and tips will increase digging efficiency.
4) For long term storage (greater than one month), put gas stabilizer in the fuel. Or you may also empty the fuel
tank by running the engine until it stops. Close the fuel shutoff valve and store in an upright position to prevent
oil from leaking.
CAUTION: ALWAYS remove spark plug wire before performing any maintenance, adjustments or repairs.
CAUTION: NEVER allow children to perform maintenance.
MAINTENANCE
4
STARTING INSTRUCTIONS
IMPORTANT NOTE: Storing the power head in temperatures below 20 Degrees F could result in difficult starting.
1) Place one finger on the red Emergency Shutoff Switch(39). Releasing this switch stops the engine and
prevents it from starting.
2) Move the choke lever to the “ON” position.
3) Move the throttle control to low. Grasp the starter cord and pull.
4) After the engine has started; slowly move the choke lever to the “OFF” position If the motor does not start
move the choke lever to the “OFF” position and pull the starter control again.
5) Once the motor is running slowly increase the throttle.