StarTech.com USB2HDCAP - Manual (Page 6)

Instruction Manual
3
Hardware Installation
1. Connect the type B connector on the included USB cable to the USB2HDCAP device
2. Connect the type A connector on the included USB cable to an available USB 2.0
port on your computer system.
NOTE: After you connect the physical hardware to the computer it is likely that you
may receive prompts for installation. Please close these specific prompts as these
steps will be performed during software installation.
3. Connect your video source (DVD, DVR, VCR, Etc.) to the HDMI, Composite or S-Video
input on the USB2HDCAP depending on the video source.
Note: If intending to capture a composite video signal, connect the composite cable
to the Component Y (Green) input.
Software Installation
After Hardware Installation the “Found New Hardware Wizard” will open, click “Cancel”
to close the window.
1. Download the latest drivers from the StarTech.com website (recommended), or
insert the included Driver and Software Disk into your DVD-ROM drive.
2. Locate the Setup(.exe) application. This file will be located in Windows directory
in the downloaded folder, or if using the included Driver and Software DVD the
installation will begin automatically.
3. The Driver installation program will begin. If a Windows Security dialog window
appears, click the “Run” or “Install this driver software anyway” option to proceed.