StarTech.com ST123HDA - Manual (Page 8)

Instruction Manual
5
2. Connect the remaining end of the composite cable to the corresponding port,
(marked INPUT) on the rear panel of the distribution amplifier. The necessary port(s)
will be labelled Pr/R/V1, Pb/B/V2, Y/G/V1. Please note: Up to three video sources can
be used, by inserting one composite video cable in each of the three input ports.
The signal that is used with the V1 input, will provide a signal to the outputs labelled
V1. Similarly, the signal that is used with the V2 input will provide a signal to the
outputs labelled V2; the signal that is used with the V3 input will provide a signal to
the outputs labelled V3.
Connecting the distribution amplifier to the display
1. Insert the connector from one end of a standard composite video cable into one of
the color-coded OUTPUT ports located on the distribution amplifier. Please note:
the video signal provided will correspond directly to the port designation. For
example, the signal connected to INPUT V1 will be transmitted through OUTPUT(s)
V1, and so on.
2. Connect the remaining end of the composite video cable used in step 1 to the
display, as designated by the video port number.