Char-Broil RED 463250811 - Manual (Page 26)

8a 19
26
Insert sideburner burner into left shelf.
shelf, shown A.
sideburner burner
Wing nut
electrode
ignitor wire
sideburner drip pan
sideburner drip pan
burner tube
The stud on bottom of burner fits into rear small hole in sideburner drip pan on
Secure burner to sideburner drip pan with one Wing nut, shown B. Under sideburner shelf, attach
sideburner ignitor wire to electrode. Make sure burner tube engages sideburner valve, shown C.
A
B
C
valve
18
#8-32x3/8” screw
4mm
lock washer
Control knob
Side burner
bezel
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia. Attach using two #8-32x3/8” screws and 4mm lock washers. Press sideburner control knob onto valve stem.
Sideburner
valve bracket
Sideburner
fascia
Valve stem
Screws and Washers
removed from valve bracket
Note: Use left and right
holes on fascia to
attach valve bracket
holes on fascia to
attach bezel
Note: Use upper and lower
Note: Make sure set the bezel with
longer slot at the top