StarTech.com NOTECONS02 Manual - Manual (Page 5)

Instruction Manual
2
Installation
Windows
Before installing the software on Windows, please disconnect the USB Crash Cart
Adapter and cancel any “Add new hardware” dialog windows. These windows can
interfere with the installation process.
1. Insert the provided USB flash drive and run the setup.exe installation program.
2. Proceed through the installation prompts to complete the installation.
3. Connect the USB Crash Cart Adapter to a free USB port on the notebook using the
supplied USB mini-B to A cable. The other connections to a server are not needed at
this point.
4. A message should pop-up entitled Found New Hardware.
5. Windows should find the device driver files and install them automatically. This is a
one-time step.
6. The product is ready to be used now, and the main application may be launched
now. There is no need to reboot.
Mac OS X
Note: For Mac OSX version 10.8 or later an exception may need to be made to run
unsigned programs. To do this hold the Command key and click on the program’s icon
to open the Applications folder. Control-click or Right-click on this icon in the Finder
window and then select Open. This will enable the program to launch normally.
1. Insert the provided USB flash drive into the computer.
2. Double-click on the MacOSX-install.dmg file on the USB flash drive.
3. After a short delay to verify the disk image, a finder window will open showing
the application and a link to /Applications. Drag the main application onto the
Applications link.
4. The application is now installed and ready for use: Find it in /Applications and
double click on it to start.
5. If you would like to add this application to the Dock, you can drag and drop it from /
Applications onto the Dock.
6. Connect the USB Crash Cart Adapter to a free USB port on the notebook using the
supplied USB mini-B to A cable.