StarTech.com SV231DVIUAHR - Manual (Page 9)

Instruction Manual 6
To start Auto Scan:
Left <CTRL> + Left <CTRL> + <F1>
To abort the Auto Scan mode, press the left <CTRL> key twice. When Auto Scan detects any
keyboard activity, it suspends the scanning till the activity stops; it then resumes with the next
computer in sequence. The length of the Auto Scan interval (Scan Time) is adjustable, see below.
Manual Scan allows users to manually switch back and forth between powered-on computers.
Left <CTRL> + Left <CTRL> + <F2>
To select the previous or the next computer, press <UP> or <DOWN> arrow keys. To abort the
Manual Scan, press any other key.
Scan Time
Four options are available for users to set the Scan Time duration, it Includes 3, 8, 15 and 30
seconds.
Note: Scan Time is set to 3 seconds by default.
To adjust Scan Rate, set the scan time of duration before switching to the next computer:
Left <CTRL> + Left <CTRL> + <F3>
The KVM Switch generates 1 to 4 beeps indicating a scan time duration for 3, 8, 15 or 30 seconds
respectively.
Audio Lock
There are two options for Audio Lock: ON and OFF.
When ON, audio selection follows computer selection. When OFF, audio selection stops
following computer selection. It is useful if you want to listen to a particular computer’s audio
signal while operating other computers.
Left <CTRL> + Left <CTRL> + <F5>
The KVM switch beeps once or twice corresponding to ON and OFF respectively.
To change which computer port the audio stays on to the currently selected port, press the
following hotkey:
Left <CTRL> + Left <CTRL> + <A>