CDA SV410 - Manual (Page 17)

Installation 1
IMPORTANT
• Appliance installation and maintenance must only be carried
out by QUALIFIED TECHNICIANS and in compliance with
local safety standards.
Failure to observe this rule will invalidate the warranty.
• Always unplug the appliance before carrying out any
maintenance operations or repairs.
• The walls surrounding the oven must be made of heat-
resistant material.
• DO NOT lift the oven by the door handle.
Installation
Locate the appliance in its housing, ensuring it is horizontal.
For improved stability, attach the oven to the unit using two screws
through the screw-holes provided on the side posts.
Make the electrical connection.
PLEASE NOTE: The rating plate should remain accessible
after installation.
For a permanent connection, make sure a system of disconnection
that complies with the installation regulations. The appliance
must be placed in such a way as to leave the plug accessible if it is
flush-fitted.
Use of an earthed power socket, connected in compliance with
current safety standards.
Your installation must be fitted with a 10 amp device for thermal
protection.
Do not use the oven if the supply cord or its plug are damaged.
In this case they must be replaced by CDA Customer Care or a
suitably qualified technician to avoid any danger.
fig. 10
450
560
50 455
20
592 448
550
378
mini
450
16