StarTech.com SAT3520U3SR User Manual
Page 7
Instruction Manual
4
4. Select the operating mode for the enclosure using the Jumper located on the inside
of the rear panel assemble (see section “RAID Mode” for details).
5. Once you have set the Mode Jumper to the desired RAID mode, connect the
external power adapter to the rear panel assembly. Turn the enclosure on.
6. Wait at least several seconds for the enclosure to fully power up then press the Reset
Button, located near the jumpers, to set the RAID mode.
7. Wait several seconds for the enclosure to initialize the RAID mode, then turn the
enclosure off, and disconnect the external power adapter.
8. Reassemble the enclosure by sliding the rear panel assembly back into the
enclosure casing.
9. Fasten the rear panel by replacing the 4 screws removed in Step 1.