StarTech.com SATDOCKU3FEU - Manual (Page 7)

Instruction Manual 4
NOTE: When connected via USB, the Dock will automatically go into Suspend Mode
if the connection is left idle for more than 5 minutes. The SATA drive will be powered
down and the fan stopped still visible to the operating system (the LED on the top
of the dock will also turn off however the LED on the rear of the dock will stay lit).
Accessing the SATA drive will automatically cancel Suspend Mode and power the drive
back up. This does not apply to eSATA connections, which are always active.
7. To remove the hard drive, make sure it is currently not being accessed by the
computer then unmount or uninstall the disk drive from the operating system (see
documentation for your operating system).
8. Press the power button to turn off the hard drive dock and wait for the drive to
power down.
9. Press the drive ejection button on the top of the hard drive dock to release the drive
then pull the drive from the slot.
Driver Installation
No driver installation is required for the compatible operating systems, as this
enclosure is natively supported, so the drivers are already installed.