StarTech.com SATDUP11IMG Quick Start - Manual (Page 7)

Instruction Manual
4
3. Connect your Target drive to the SATA SSD/HDD Target Port on the
SATDUP11IMG.
Note: The Target Drive can be a drive you intend to overwrite with another drive
image, or an Image drive you intend to add an additional drive image to.
a) If the target drive is a SATA HDD/SSD, use the included Long SATA cable or the
included Short SATA cable depending on your preference.
b) If your target drive is an eSATA HDD/SSD, use the included eSATA + 12V Power
Cable or eSATA+5V Power Cable depending on your drive requirements.
4. For added drive protection and heat insolation, place the source drive and target
drive on top of each, of the included SSD/HDD Pads.
5. Set the Power Switch to the on position. The SATDUP11IMG is now ready to use.
Hardware Operation
Create an Image Library Drive/Add an Image to your HDD Image Library Drive
Note: The target drive must be larger than the source drive to create an Image Drive,
or add an HDD image to your Image Drive. The Image Library Drive must also be
formatted correctly to be recognized as an image drive. Be aware that any previous
data on the library drive will be overwritten if it need to be setup as a library drive.
1. Using the UP/DOWN Navigation buttons and the Display Screen, locate 1.Copy
from the on screen menu, and press the OK button, to access the [Copy] sub menu.