StarTech.com AP300WN22WUE - Manual

Quick Start Guide
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
Manual Revision: 08/07/2014
For the most up-to-date information, please visit: www.startech.com
Packaging Contents
• 1 x In-Wall Access Point
• 1 x Faceplate
• 1 x Frame for Faceplate
• 2 x Screws
• 2 x Washers
• 1 x Quick Start Guide
• 1 x Instruction Manual CD
System Requirements
• 802.3af / at compatible PoE Switch
• Cat 5e (or better) Ethernet cabling from PoE switch to the Access
Point
• 1 gang receptacle box
LED Indicators
Installation
AP300WN2X2W / AP300WN22WUE
300Mbps Wireless N PoE-Powered Wallplate Access Point
*actual product may vary from photos
Front View
Rear View
Reset Procedure
Default Settings
To reset the unit to factory defaults, press and hold the AUX and
Reset buttons simultaneously for 5 seconds and then release.
Default IP Address: 10.59.1.200
Username / Password: admin / admin
1. Slide the Frame over the back of the AP and secure using the
provided screws w/ washers.
Ethernet Connector
(transparent)
LAN Connector AUX Reset
Button
PoE Power / Data
Connector
Ethernet Connector
(transparent)
LED State Description
PWR
Off No power
Green Unit powered on
SYS
Off Remains off while the unit is initializing
Green Initializing complete, system is ready to use
Green (Blinking) During firmware upgrades, this system LED will blink
Link/
WAN
Off No network connector
Green 10/100Mbps network connection established
Green (Blinking) Indicates WAN activity
LAN
Off No network connection
Green 10/100Mbps network connection established
Green (Blinking) Indicates LAN activity
WLAN
Off The Wireless is not ready
Green Wireless connection established
Green (Blinking) Indicates Wireless activity