StarTech.com ATX2POWER450 - Manual (Page 6)

Instruction Manual
3
Check that the orientation with the screw holes in your case is correct; all four holes
must be aligned. Support the power supply with one hand while threading a mounting
screw through the back of the case and into the power supply. The screw should
thread smoothly and should not require effort. Do not force it or you could damage the
mounting holes. If the screw won’t thread smoothly, remove it and check to ensure the
mounting holes are correctly lined up. Repeat for the remaining three screws. Do not
fully tighten any of the screws until they all have been threaded into their mounting
holes. (Note: Consider Startech part SCREWTHUMB screws for easier installation.)
9. Tie unused wires away from fans and other moving parts.
10. Replace the case cover and secure it.You may wish to not replace the screws until
after you have checked that all connections are working.
11. Toggle the rear power switch on power supply to off. (The “0” symbol on the
switch.) Connect the power cord to the power supply and plug it in to a grounded
power outlet. (The power supply MUST be connected to a grounded outlet.) Toggle
the rear power switch to on.
12. Start your computer.You should hear its fans and devices immediately begin to run. If
you do not, toggle the rear switch on the power supply to off, disconnect the power
cord, open the case and check that all connectors are well seated and secure.
13. When you have confirmed all connections are working, replace the screws in your case.
14. Power supplies contain electrical and electronic components and should be
disposed of properly. If you are replacing a power supply, please follow your city’s
rules for proper disposal of electrical equipment.