Studio Electronics SE-1X User Manual
Page 17
BANK 1: Original Factory Standard Sounds: Bank A
BANK 2: Original Factory Standard Sounds: Bank B
BANK 3: Lexington G Sounds
BANK 4: Allec Series Sounds
BANK 5,6: User Sounds
BANK 7,8: Random (Some of our best sound effects were created from
these scrambled patches!). Call us for an explanation (easier to speak
than type) on how to remove random characters and values in the edit
windows, and keep that magic sound of the patch the same; we’re thinking
you’ll probably figure this out on your own. Tak.
PLEASE NOTE: Version 0.72 units have missing patches in ROM banks
3 and 4. Sounds from 35 - 99 are missing. Unfortunately we were unable
to fix this before a handful of units shipped. All we can say is: D@#! – our
software developer best be enjoying his sun soakin’ in Mexico. Not to
worry, this problem will be fixed by the time you receive your unit, as you
will most likely have been contacted by us prior to reading this.
You will read this - Won’t you?
BANK 1: Original Factory Standard Sounds: Bank A
BANK 2: Original Factory Standard Sounds: Bank B
BANK 3: Lexington G Sounds 1-35
BANK 4: Allec series Sounds 1-35
BANK 5: User 1-35, Lexington G 36-99
BANK 6: User 1-35, Allec Series 36-99
BANK 7: User Sounds
BANK 8: Those Parabolical Random Sounds
Saving Patches from ROM to RAM (version 0.72)
You’ve changed a ROM patch and want to save your edits. Press “save”;
this will be a little confusing for the now - we’ll clear it up in version 0.73,
and your trusty backlit LCD screen displays:
SAVE 01 (patch number) TO: the name displayed here will be the
corresponding patch name in bank 5, on the line below, BANK 1 will still
be displayed. To actually save to this bank 5 location you will have to
press the bank up switch; the screen will then display BANK 5. From here
you can keep pressing the bank up switch to the desired bank, as well as
rotating the encoder to select the desired patch location. After you have
chosen your desired bank and patch location press “save” again. Pressing
“exit” will abort this procedure. Note: after pressing exit it will seem as
though you have saved the patch to that location, but it is there in name
only. The name will disappear after changing patches.