Casio E MULTI PJ CAMERA Multifunctional Camera System - Manual (Page 75)

75
OTHER RECORDING FUNCTIONS
4. Press the shutter release button to start voice
recording.
• The remaining recording time value counts down on
the monitor screen and the green operation lamp
flashes as recording is performed.
• Pressing the [DISP] button during voice recording
turns off the monitor screen.
• You can insert index marks while recording by
pressing [SET]. See page 106 for information about
jumping to an index mark during playback.
5. Recording stops when you press the shutter
release button, when memory becomes full,
or when the battery goes dead.
NOTE
• You can also enter the Voice Recording Mode by
aligning the mode selector with “REC”, and holding
down [DISP] as you press the power button to turn
on the camera. In this case, the camera goes directly
into the Voice Recording Mode without extending the
lens.
■ Audio Recording Precautions
• Keep the microphone on the
front of the camera pointed
at the subject.
• Take care that you do not
block the microphone with
your fingers.
• Good recording results are not possible when the camera
is too far from the subject.
• Operating camera buttons during recording can cause
button noise to be included in the audio.
• Pressing the power button or changing the mode selector
setting stops recording at that point and stores any audio
recorded up to that point.
• You can also perform “after-recording” to add audio to a
snapshot after recording it, and also change the audio
recorded for an image. See page 103 for more
information.
Microphone