Studio Electronics C.O.D.E. - Manual (Page 9)

8
Programmer
Knobs
Q dial: use for changing patches and editing on screen parameters.
Switches
left arrow: moves the cursor left.
right arrow: moves the cursor right.
up down arrows, bank / part: moves the cursor up and down, changes patch banks when the
display is on the main page.
compare: compares edited patch to programmed patch.
exit: returns display to main page.
save: saves current patch to same or chosen location. Patches from either bank can be saved
to either bank at any location.
X10 for edits to the pan page, makes numbers increment in multiples of 10.
tune: tunes the oscillators, procedure takes about 23 seconds.
global:
page 1: set to the corresponding number of voices in your Omega
page 2: uploads RAM banks to ROM banks, rotate encoder after “are you sure?” to initiate.
page 3: set number of filters in unit. Standard units set to 2 for SEM and Moog.
Oscillators
Knobs
frequency: adjusts oscillator frequency.
pulse width: adjusts width of square wave.
oscillator level: adjusts oscillator mix level.
noise: adjusts noise mix level.
Switches
triangle, saw tooth, square: oscillator waveforms on / off.
sub: oscillator 1 sub waveform.
sync: syncs frequency of oscillator 2 to oscillator 1 frequency.
edit
page 1: master tune, oscillator 1 and 2 frequency. When in this page the Q dial may also be
used to edit oscillator frequencies.
page 2: [FINE] oscillator 2 fine tuning, [MODE] oscillator 2 pitch modes, [ENV1] amount of
oscillator 2 frequency modulated by envelope 1.