Studiologic Studio 90 plus - Manual (Page 9)

SPLIT TRANSPOSER LOWER
TRANSPOSER UPPER
MIDI OUTS
FOOT - SWITCH
POWER INPUT
ON
OFF
TRANSPOSER SPLIT
LOWER UPPER
SPLIT
To split the keyboard in two parts all you do is press the key wish to be the
dividing point on the keyboard then press the switch «SPLIT».
Obviously once split, the keyboard is separated in two distinct parts, the LOWER
part will go through channel MIDI 1 and the UPPER part through channel MIDI 2.
If you press only «SPLIT» and no key the entire keyboard will transmit trough MIDI 1
TRANSPOSER
LOWER: to transpose the LOWER part of the keyboard press the note you want to
correspond to initial A then press the switch «LOWER».
UPPER:to transpose the UPPER part of the keyboard press the note you want to
correspond to the first key of the split then press «UPPER».
When you split, transposition will be automatic, the lower part will increase by one
octave and the upper part decreases by one octave.
TECHNICAL DATA
Supply will require a standard adapter with a variable continuous out put voltage
ranging 9 to 12 V and 350 mA current minimum.
The keyboard includes two midi outputs to pilot other instruments.
Ther is also a FOOT-SWITCH jack to wich you can connect an OFF-ON pedal wich
will enable a sustain effect through midi of the popular synthesizers and expanders
on the market.
STUDIO 90 STUDIO 90 PLUS
15 14
STUDIO 90 STUDIO 90 Plus
PLUS 1
Param. Value Prog. Enter
2 3 4 5
6 7 8 9 0
INTRODUCTION:
Thank you for purchasing the FATAR Studio-90 Plus, the finest feeling master controller on the market
today. The action is a result of many years of engineering that went into the keyboard mechanism. There are
actually hammers that strike a surface that simulates a piano string.
The FATAR Studio-90 Plus master controller is very simple to operate once you understand its capabilities.
Even though the controller seems to be always in split mode, you can layer or split one, two, or three sounds
across the entire length of the keyboard. However, you must be aware of the specific use of each parameter to
get the desired results.
FEATURE LIST: The following is a feature list of the ST-90 Plus master keyboard controller.
Power Supply: 110 V
Fuse: 1A, 250 V, GGS 5 X 20 mm.
88 Note Weighted Hammer Action Keys
Key measurements like a real piano
Dynamic Range (00-99)
Velocity Sensitivity Release (00-99)
Three Zones Programmable
Half-tone transposition
Octave transposition
Three MIDI Outputs
Foot-Switch Control
Program Change Footswitch
Pitch and Modulation Wheels
Outputs on all 16 MIDI Channels (three channels at one time)
100 Performance Programs (00-99)
Two digit numeric display
Beautiful Cabinet Design
Also available in sturdy case road case