CLIFFORD Arrow II - Manual (Page 12)

Adding new remote controls
For other drivers in your family, or if you wish to control Clifford systems on your
other cars with the same remote control, you can buy additional remote controls
from any Clifford Dealer (or call our Customer Service Department at
800-824-3208) and program them into the system yourself. Each Arrow II will
respond to as many as three 3-channel and/or 12-channel ACG remote controls. To
add a new remote control to the system, use the procedures noted in the
User-selectable features section on page 10.
How to erase the codes of lost or stolen remote controls
If one of your remote controls is ever lost or stolen, you can erase its digital codes
from the system memory to make sure that the missing remote control can never be
used to disarm your system. To do so, use the “Erase all channels” feature (see
User-selectable features on page 10). This will clear all remote control codes from
the system memory. Then simply program each remaining and/or replacement
remote control as noted in the Adding new remote controls section above.
Arrow II is covered by one or more of the following
Clifford Electronics patents: 4,158,874; 4,233,642; 4,327,444; 4,383,242;
4,430,685; 4,845,464; 4,887,064; 4,890,108; 4,922,224; 4,997,053;
5,081,667; 5,146,215; 5,157,375; 5,467,070 and other patents.
For a Clifford Dealer near you, call 1-800-CLIFFORD or visit our Internet Website at
http://www.clifford.com
Example : To change the AutoArming feature from its factory
setting of “on” to “off,” you would do the following:
•
Turn the ignition key to the ON position.
•
Immediately flip the valet switch back and forth 4 times (you’ll
hear a chirp each time you flip the switch back and forth to help
you count to the total of 4 chirps).
•
Turn the ignition off. That’s all there is to it! To change the
AutoArming setting back, just repeat the procedure.
© Copyright Clifford Electronics, Inc., 1996 31-700D/A2OM/696