Sure Heat 2008 Amana AM33 - Manual (Page 30)

Gas Supply Line Pressure Testing
Testing above ½ psi (3.5 kPa) or 14" (35.5 cm) WCP (gauge):
The grill and its individual shutoff valve must be disconnected from the gas supply piping system
during any pressure testing of that system at test pressures greater than ½ psig (3.5 kPa).
Testing below ½ psi (3.5 kPa) or 14" (35.5 cm) WCP (gauge) or lower:
The grill must be isolated from the gas supply piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply piping system at test pressures equal to or less
than ½ psig (3.5 kPa).
INSTALLATION INSTRUCTIONS
20 lb LP Gas Fuel Cylinder
This grill is equipped for use with a 20 lb LP gas fuel cylinder (fuel cylinder not supplied). A gas
pressure regulator/hose assembly is supplied.
It is also design-certified by CSA International for local LP gas supply. The 20 lb LP gas fuel cylinder
must be mounted and secured.
Set 20 lb LP gas fuel cylinder in hole in the cart base. Use the cylinder secure ring to secure the
cylinder in position.
INSTALLATION REQUIREMENTS
Make Gas Connection
LP Gas:
IMPORTANT: A 20 lb LP gas fuel cylinder must be purchased separately.
IMPORTANT: The gas pressure regulator/hose assembly supplied with the grill must be used.
Replacement gas pressure regulator/hose assembly specific to your model, is available from your
outdoor grill dealer.
To Install the 20 lb LP Gas Fuel Cylinder:
1. Set cylinder in hole in the cart base.
2. Screw the gas pressure regulator/hose assembly on to the 20 lb LP gas fuel cylinder as shown.
3. Place the cylinder secure ring over the cylinder collar as shown.
4. Turn on the gas supply. Wait a few minutes for gas to move through the gas line.
5. Test all connections by brushing on an approved non-corrosive leak-detection solution. Bubbles
will show a leak. Correct any leak found.
Cylinder
connection
Regulator Inlet
Connector
30