Sure Heat Sonoma SGIR30 - Manual (Page 9)

BEFORE LIGHTING
Important! Before Lighting:
• Check the gas supply line for cuts, wear or abrasion.
• Always keep your face and body as far away from the grill
as possible when lighting.
GRILL BURNER LIGHTING
Lighting the Grill with electronic igniter
1. Make sure all control knobs are in the “OFF” position.
2. Open the gas supply valve located on top of your L.P. tank.
ATTENTION: When turning the L.P. tank on, make sure to
open the valve very SLOWLY two (2) complete turns to
insure proper gas flow.
3. Always open the hood before attempting to light.
4. Push and turn one of the control knobs counter clockwise
to the “HIGH” position and immediately press the electronic
igniter button. You will hear a snapping sound. It may be
necessary to hold the electronic starter button for about 4
seconds. (See Fig. 21)
NOTE: If the burner does not light in 4 seconds, turn the
knob to the “OFF” position and wait 5 minutes before
trying again.
5. Repeat above steps to light remaining burners.
Match Lighting
If by chance the electronic igniter does not light the burner,
the burner may be lit with a match attached to the match
extender, located on the inside of the cart door.
Keep your face as far away from the grill surface as possible
and pass the match extender through the spaces in the grill
grates to the ports of the back crossover burner between the
flavor grids. Position the match near the burner ports and push
and turn the control knob counter clockwise to the “HIGH”
position. (See Fig. 22-23)
The match extender can be stored inside the cart door by
sliding the extender ring through the opening on the inside,
back of the cart door. (See Fig. 24-25)
NOTE: If the grill will not light after several attempts see
the trouble-shooting section of this manual. Turn the
control knobs to the OFF position when not in use.
9
Do not attempt to “Light” the grill if the odor of gas is present!!
Fig. 21
Fig. 22
Fig. 23
Lighting the Grill
Crossover Burner
Fig. 24 Fig. 25