Installation instructions, Make gas connection, Check the burners – Sure Heat 2009 Surefire SF30HOLP User Manual

Page 9

Advertising
background image

9

INSTALLATION

INSTRUCTIONS

Make Gas Connection

Explosion Hazard

Do not store fuel tank in a garage or indoors.

Do not store grill with fuel tank in a garage or

indoors.

Failure to follow these instructions can result in

death, explosion, or fire.

LP Gas:

IMPORTANT: A 20 lb LP gas fuel tank must be purchased

separately.

IMPORTANT: The gas pressure regulator/hose assembly

supplied with the grill must be used. Replacement gas pressure

regulator/hose assembly specific to your model, is available from

your outdoor grill dealer.

To Install a 20 lb LP Gas Fuel Tank:

Open Access Door and place tank inside base.

1.

Screw the gas pressure regulator/hose assembly on to the

2.

20 lb LP gas fuel tank as shown.

NOTE: The 20 lb LP gas fuel tank orientation shown in the

illustration above must be followed to provide proper vapor

withdrawal.

3. Turn on the gas supply. Wait a few minutes for gas to move

through the gas line.

4. Test all connections by brushing on an approved

non-corrosive leak detection solution. Bubbles will

show a leak. Correct any leak found.

A. 20 lb. LP gas fuel tank

B. Gas pressure regulator/hose assembly

A

B

Check the Burners

The burners are tested and factory-set for most efficient

operation. However, variations in gas supply and other

conditions may make minor adjustments to air shutter or low

flame setting necessary.

It is recommended that a qualified person make burner

adjustments.

Checking the grill burner flames requires removing the grate

and flavor grids.

Burner Flame Characteristics

The flames of the grill burners and side burners (on some mod-

els) should be blue and stable with no excessive noise or lifting

(LP gas flames will have a slightly yellow tip). A yellow flame

indicates not enough air. If flame is noisy or lifts away from the

burner, there is too much air. Some yellow tips on flames when

the burner is set to HI setting are acceptable as long as no car-

bon or soot deposits appear.

Check that burners are not blocked by dirt, debris, insect nests

etc. and clean as necessary.

Advertising