Sure Heat Sonoma PFCIS - Manual (Page 5)

5
INSTALLATION INSTRUCTIONS
Before Using Your Unit
• Remove the exterior and interior packing.
• Before connecting the unit to the power source, let it stand unpright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Setting the Temperature Control
• Your unit has only one control for regulating the tempertature in the compartment. The
temperature control is located on the upper side of the compartment.
• The first time you turn the unit on set the temperature control to "5".
• The range of the temperature control is from position "OFF" to "5". "1" is warmer and "5" is
cooler. After 24 to 48 hours, adjust the temperature control to the setting that best suites your
needs. The setting of "3" should be appropriate for normal use.
• To turn the appliance off, turn the temperature control to "OFF".
Electrial Connection
• Turning the temperature control to "OFF" position stops the cooling cycle but does not shut off
the power of the unit.
• If the unit is uplugged, has lost power or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
Food Storage
• Use plastic wrap to keep food and place evenly on wire rack.
• Let hot food cool down before putting into this refrigerator for saving energy.
• Don't open door frequently.
• Keep space betwwn foods inside refrigerator.
• Keep food dry before storage.
Installing Your Unit
• Remove food from refrigerator when power is out.
• Place your unit on a floor that is strong enough to support the unit when it is fully loaded.
• Locate the unit away from ditect sunlight and sources of heat (stove, heater, radiator, etc). Direct
sunlight may affect the acrylic coating and heat resources may increase electrical consumption.
Extreme cold ambient temperatures may also casue the unit not to perform properly.
• Plug the unit into an exclusive, properly installed-grounded GFI wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing food to the refrigerator compartment.