Sure Heat T87PHLP Patio Heater - Manual (Page 15)

Assembly Process
15
Standard 20lb. tank
Screw regulator onto gas hose. Do not cross-thread. Tighten securely.
Install cylinder.
Attach regulator to cylinder.
Complete attachment.
Step 9 - Connect Hose & Regulator to Cylinder
Specifi cations
- You must provide propane gas and propane cylinder. Use a
standard 20 lb. Propane cylinder only.
- Use this heater only with a propane vapor withdrawal supply
system. See Chapter 5 of the Standard for Storage and
Handling of Liquefi ed Petroleum Gas, ANSI/NFPA 58. Your local
library or fi re department should have this book.
- The minimum permissible gas supply pressure of 10 W.C. is
required for purpose of input adjustment.
- The installation must conform with local codes, or in absence of
local codes, with National Fuel Gas Code, ANSI Z223.1.
- The minimum hourly output of 17000 Btu is the required rating of
a heater operating at ratings less than full input rating.
- The pressure regulator and hose assembly supplied with the
appliance must be used.
- A dented, rusted or damaged propane cylinder may be
hazardous and should be checked by your cylinder supplier.
Never use a propane cylinder with a damaged valve connection.
- The propane cylinder must be constructed and marked in
accordance with the specifi cation for LP gas cylinders of the U.S.
Department of Transportation (DOT).
- Never connect an unregulated propane cylinder to the heater.