ClearSounds V508 - Manual (Page 17)

16 – ENGLISH 17 – ENGLISH
trouBLeSHootInG
If you have problems with your CSC600, please check below for
helpful hints.
no dial tone
1 Check that all phone cord connections (including the curly cord) and AC
Adapter are securely plugged into the telephone & wall jack.
2 Check that the phone is in the correct dialing mode, Touch-Tone / pulse
Setting.
3 plug another phone into the jack to make sure your phone service is
functioning properly.
Call will not dial or dials very slowly
1 Check that the phone is in the correct dialing mode, Touch-Tone / pulse
Setting
no audible ringer
1 Make sure the ringer is not set to the “oFF” position
2 Check the volume level of the ringer.
3 You may have too many extensions on your line. Try unplugging a few
devices. Having too many telephones /accessories can also create
problems such as low ringer volume or impaired quality during calls.
no Strobe ringer and/or bed shaker will not activate
1 Make sure the strobe and/or shaker switch is turned “oN”
2 Make sure the Bed Shaker is plugged in all the way.
3 Make sure the Bed Shaker is plugged into the correct jack.
no amplification
1 Check to see if the AMpLI amplify button is “oN”. The red light should
be lit.
2 Check the AC power Adapter and make sure it is plugged into the wall
and into the appropriate jack on the phone. If necessary change the
adapter to a different outlet.
noise, Static, Interference while using the handset
1 A filter may be required for homes with DSL line or near Radio towers.
there is a red light that continues to flash
1 You have un-reviewed Caller ID / Call Waiting information or missed a
call.
2 Your Voice Mail account needs to be set-up as Visual Indicator only.
Contact your local phone company; if the account is setup as Audible or
CSC-600-TriLingual.indd 17 6/2/08 1:38:35 PM