Cary Audio Design CAD-211M - Manual (Page 5)

5
INSTALLATION
This section describes the unpacking and installation procedures for the CAD-211M
mono-blocks.
2.2
Unpacking
All shipping containers have been specifically designed to protect its contents and special
care has been taken to prevent damage under normal shipping conditions. Mishandling
should be evident upon inspection. If damage is found, take care not to destroy the
evidence. Document any damage with photographs and contact the transport carrier
immediately.
Carefully remove the CAD-211M amplifier from its packing carton and examine closely
for signs of shipping damage. Save all original packing cartons for future storage or after-
sale service.
2.3
Warranty Card
Fill out the enclosed Warranty Registration Card and return to Cary Audio Design within
10 days of the original purchase. Keep your original sales slip and packing cartons for
future reference. Failure to register warranty will limit the warranty to one year.
2.4
Amplifier Placement
In general, the location of the CAD-211M amplifier is not critical. The best placement of
the amplifier is near the speakers with short lengths of speaker cables. Certain precautions
must be taken to avoid radiators or other heating units. Keep the top of the CAD-211M
clear of books, paper or other equipment to protect against overheating.
WARNING
Do not attempt operation without the
bottom plate attached. Contact with
voltage in the
CAD-211M can be fatal!!!