Crown Audio Pulse 21100 - Manual (Page 7)

7
Inputs
For each channel, there is a 1/4” phone jack socket, male & female XLR and pluggable removable terminal
block connectors provided for signal input on the rear panel of the amplifier. Each is electronically balanced
at an impedance greater than 10k ohms.
The removable terminal block, phone jack and both XLR connectors are internally wired in parallel, and
therefore any socket may be used for the input signal. The connectors not used in this manner function as
loop-through connectors for daisy chaining a number of channels.
The ‘HOT, + or in phase’ connection for the removable terminal block is to pin 2 of the XLRs and the TIP of
the phone jack.
The ‘COLD, -, or out of phase’ connection for the removable terminal block is to pin 3 of the XLRs and the
phone jack RING.
The removable terminal block earth symbol pin, pin 1 of the XLR’s and the phone jack SLEEVE are internally
connected to the chassis. The screen of the input cable should always be connected to one of these points to
ensure that EMC regulations are met. The cable shield ground should also be connected to the equipment
which is providing the input signal.
When feeding the PULSE 2x1100 from unbalanced sources, connect the signal conductor to the + pin of the
removable terminal block, pin 2 of the XLR or the phone jack TIP, with the cable screen going to pins - and
ground of the removable terminal block, 1 and 3 of the XLRs or the SLEEVE and RING of the phone jack.
For bridge mode operation, channel 1 is used as the input signal for the amplifier. The channel 2 input is
ignored when bridge mode is enabled.
4 . 0 A u d i o C o n n e c t i o n s
balanced wiring to pulse phone jack
balanced wiring to pulse XLR
Unbalanced wiring to pulse XLR
Unbalanced wiring to pulse phone jack