Century Avanta - Manual (Page 14)

Adjustable Handle:
• Handle has three adjustment positions.
• Push in red buttons on each side of
handle, rotate and release red buttons.
Continue rotating handle to desired
position until you hear a “click” sound.
• IMPORTANT: Before lifting car seat, place
handle in “locked” upright carrying
position.
Removing Car Seat from Base:
• Place handle in “locked” upright carrying
position.
• Squeeze red release handle in base (fig. b).
• Lift car seat out of base.
Adjusting Car Seat Recline (2-Positions):
• Squeeze lever up and rotate car seat
to Reclined or Semi-reclined position
(fig. c).
• Release handle.
Adjustable Base:
• Pull Level Adjuster Handle out (fig. d).
• Adjust Foot to desired position.
• Release adjustment handle. Be sure it
retracts into slot.
Harness Straps (fig. a):
• To tighten: Pull lower belt tab.
• To loosen: Pull and hold upper belt tab
while pulling harness straps.
Buckle:
3-Point Models
• To buckle: Push tongue down into slot.
Pull up on tongue to be sure it is locked.
• To unbuckle: Press red button and pull
tongue out.
5-Point Models
• To buckle: Insert both tongues into
buckle. Pull up on tongues to be sure
they are locked.
• To unbuckle: Press red button and pull
tongues out.
2-Piece Harness Tie:
• To open: Squeeze tabs and pull apart.
• To close: Snap halves together. Make
sure harness tie is locked by pulling out
on each half.
OPERATIONS and ADJUSTMENTS
12
1
2
3
5
6
7
4