TC-Helicon VoiceLive 3 - Reference Manual - Manual (Page 18)

Introduction
VoiceLive 3 – Reference manual (2014-03-29) 16
3. Step footswitch
– To move to the next Step within
the current Preset (from 1 to 2
etc.), tap the Step footswitch.
! Not all Presets have Steps.
– To move to the previous Step in the current
Preset (e.g. from 2 to 1), tap the Preset Down
footswitch.
– To enter the Step management screen, hold
the Step footswitch.
Step management
Step management
You can use the current Preset or a different Pre-
set as a Step.
If you are using the current Preset, make sure
that it sounds the way you want it to before you
enter Step management.
Adding a Step to a Preset
If it is a different Preset, enter Step management
and then use the Preset Up and Preset Down
footswitches to locate the Preset you would like
to add as a Step.
Adding a different Preset as a Step
– To accept changes, tap Step.
– To delete the current step, tap the Layer foot-
switch.
– To cancel, press Home.
The Step footswitch can be Globally reassigned
to several different functions – such as Tap Tem-
po, HIT, Set Key, any Vocal or Guitar effect and
more. We have found that remapping Step to
enter/leave the Looper can be incredibly useful
in performance, when you need quick access in
and out.
For more information about Steps, see “Using
Steps”.
4. µMod footswitch
Tap the µMod footswitch to turn the
micro-modulation (µMod) effect on
or off.
The µMod block encompasses effects such as
Chorus, Flange, Detune and Rotor.