TC-Helicon VoiceLive Touch Quick Start - Manual (Page 7)

10. TALK BUTTON - Tap to mute all
effects except Tone. Hold to access
guitar Tuner.
3. LEDs - Input and Clip show signal
present(green) and input too high
(red). MIDI indicates MIDI input. An
unlabeled flashing LED shows the tap
tempo of the current preset.
Front Panel
7
8. THE SLIDER - Swipe, drag or tap the
Slider to load presets or change values in
edit modes. Tap to display preset name
or parameter and value in edit modes.
Hold to enter Wizard that assists in
browsing presets according to category.
Double tap anytime to exit to Home.
7. ARROW BUTTONS - Tap either
arrow to increment presets in Home
mode. Tap either to browse menus in
edit modes. Hold Left arrow to undo
last loop overdub. Hold right to extend
loop length 2x.
2. HARMONY VOICING - Tap
any four to choose harmony voice
arrangements. Hold any lit Voicing
button to edit.
5. DISPLAY - Shows current Favorite
bank and number (FAV1-5, B1-5, C1-5
etc.) or preset (e.g. 105). Also shows
edit parameters and values.
4. MIX BUTTON - Tap to enter mix
menu then use arrows to select and
Slider to adjust. Tap Mix again to exit.
Hold Mix to enter Setup menu and set
phantom power, Tone, MIDI channel
and more.
9. FAVORITE BUTTONS - Tap a Favorite
button to jump to presets you use most
often. Hold to store preset and any edits
as a Favorite. To select Favorite banks A
to E, briefly hold the Slider, immediately
tap a Favorite and release.
6. LOOP CONTROLS - Tap red button to record and again to loop.
Tap green to stop and play. Hold red to Erase loop. 1. EFFECT BLOCKS - Tap any effect block to turn it on or off. Hold to
edit, then tap to exit. Holding the Delay button is used to set tap tempo.
1
2
3
4
5
6
7
8
9
10