TC-Helicon VoiceTone Create Manual - Manual (Page 39)

39
Quick Setup
1. Connect the mic/cable to the Mic Input on Create
2. Connect a mic cable from the Left (mono) Output of
Create to a mic input on your sound system.
3. Set the Input Knob fully left, and the Mix Knob to 12
o'clock.
4. Connect Create's power adapter to main power and to
the Power Input on Create.
5. While singing through your microphone, turn the Input
Knob to the right until the Input Light turns green, sometimes
orange on louder parts, but never red.
6. Turn up your sound system level. You're ready to add
effects to your voice.
Information for Your Sound Engineer
Don’t Worry
It can be a scary night when a singer brings an effects pedal to
a gig and you are expected to get good sound. Don’t worry,
VoiceTone Create has a quality mic pre with 109 dB SNR, and
the patches are authored specifically for voice.
Phantom Power
Create can supply phantom power to a condenser mic - press
and hold Buttons 1 & 2 until the 48V light turns on. Sending
external power to Create will not cause damage, but there will
be a pop when power is removed.
Output Level
The outputs on Create are +1dBu, just like a hot condenser
microphone.You won’t need a DI box.
Output Configurations
If you want to mix wet and dry yourself, take Create out of
stereo mode (hold Buttons 4 and 5 until the Stereo light turns
off) and turn the Mix Knob fully right. In this configuration, the
Left Output is fully wet and the Right Output is fully dry.
Tear-Out | Reference
Tear this page out,
plasticiz
e it and car
ry
it with y
ou to gigs f
or ref
erence