TeeJet FENDT-INTERFACE User Manual
Page 3
Advertising
3
3:
Monitor-cable. Each wire is provided with a number which corresponds to the
numbers of the plugs on the rear of the monitor.
4:
Socket for connection of an external area counting on/off sensor.
PIN
FUNCTION
1
Signal
2
+ 12 Volt (output for sensor)
3
0 Volt
SWITCH 1:
This switch changes between stop of area counting by the lift or by an external sensor (see plug
4 above).
Signal from external sensor.
Signal from lift.
SWITCH 2:
This switch chooses which speed sensor is to be used.
Signal from gear box (wheel).
Signal from radar (if mounted).
Advertising