TeeJet FieldPilot Install Spra Coupe 44XX 4-Wheel - Manual (Page 16)

www.teejet.com
15
FieldPilot ®
7. INSTALL PRESSURE AND EXCESS FLOW HOSES
Remove the steel line that goes from the Charge Valve to P port of the steering orbital. It may be necessary
to remove the hose and fitting next to the P port to gain access to the P port steel line. Install fitting (DD) in
port on the charge valve. Install hose (U) from the charge valve fitting (DD) to the P port of the FieldPilot
Valve (G) . Install hose (T) from EF port on the FieldPilot Valve (G) to the P port of the steering orbital.
Route the hoses along the right side of the support frame above the engine. It may be necessary to cut some
of the foam to allow room for these two hoses and cable to fit properly.
Figure 1-12: Install Pressure and Excess Flow Hoses
U
DD
T