THORENS TD 2030 - Manual (Page 24)

Carefully remove the unit and its accessories from the
shipping box.
Supplied items:
ATTENTION: The surface of both plinth and plat-
ter is quite sensitive to scratches. It is therefore
recommended to wear the supplied gloves whilst
the record player is being assembled.
1 x user manual
1 x plinth (with/without tonearm)
1 x motor in housing
1 x Thorens drive belt
1 x platter with felt mat
1 x tonearm counterweight
1 x electronic control unit PS 800
1 x mains adaptor
1 x power cord
1 x set of RCA interconnecting leads
1 x adaptor for single records
3 x protective disks
2 x cotton glove
Proceed with placing the three protective disks where the
record player is eventually going to stay. They are provid-
ed to prevent the sensitive surface of furniture from being
damaged by the record player’s spiked feet.
Now put the record player respectively its feet onto the
disks and after the final position has been achieved make
sure that the plinth is fairly level. For any fine-adjustments
turn the tip of each foot up or down until the plinth is in
a perfect horizontal position. This procedure is best con-
trolled (and corrected if necessary) with the help of good
spirit level.
The motor housing is now to be inserted into the dedi-
cated recess at the rear left corner. This is carried out by
having the plinth lifted up and the motor positioned exactly
beneath the recess. Slowly lower the plinth so that the
motor housing is entering the recess. Great care should
be taken while doing this in order to prevent any scratches
on the plinth surface. Being in its final position the motor
housing should not be touching the inside of the recess.
24