Tie Down Bunk Guides 60 - Manual

0
42
20
3,
10
1
60" BUNK GUIDES
Assembly Instructions
Stk # 86124
Thank you for purchasing the Long Run Bunk Guides. Please review the following instructions
before starting the assembly. With proper care, the Bunk Guides will give you years of service.
Tools Required:
9/16" Deep Socket, 9/16" Wrench,
Phillips Head Screw Driver
Parts List
Desription Qty
60" Carpeted Bunks 2
34" x 1-1/2" sq. Support Tube 4
Upper Mounting Plate 4
Lower Mounting Bracket 4
3/8"x 5" Hex Head Bolt 16
3/8"x2.5" Hex Head Bolt 4
3/8" Hex Nyloc Nut 20
3/8" Flat Washer 40
Plastic End Cap 4
Hex Head Screws 8
Swivel Mount Brackets 4
1. Before assembling the mounting hardware as shown in figure 1, decide
where you will want the bunk guides placed on your trailer. Mounting
brackets should be placed 3' to 4' apart to provide support for the 60"
bunks.
2. Using 4 - 3/8"x 5" hex head bolts, 8 flat washers and 4 nyloc nuts, for
each, attach the guide support mounts onto your trailer frame, as shown in
figure 1. Use the holes that will keep the bolts closest to the frame tube.
Finger tighten at this time. Repeat for support mount.
3. Slide the guide support tube into each assembly as shown in figure 2.
4. Use a 3/8"x 2-1/2" hex head bolt and nyloc nut to attach a swivel bracket
to each support tube as shown in fig 3. Top mounting hole should be used.
Swivel bracket should be mounted on the "outside" of each support
mount. Tighten bolt to allow swivel bracket to stay in place when moved.
5. Center the bunks on the support brackets and attach the bunks using 2
phillips head screws at each swivel bracket (Fig 3).
6. Adjust the guide tubes for the proper distance on each side. Tighten
support mount bolts at this time. Adjust the bunks for the proper angle
and tighten the bolts.
Instructions # 15345
Front
Out
Figure 1
Front
Out
Figure 2
Figure 3