Tie Down 86466 - Manual

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401 052714,A1073
Low Rider
Guide On’s
Model #86466
Item Numbers:
# Qty. Part # Description
1 2 43765A Guide Tube Assembly
2 8 10627 Nylock Nut 3/8”
3 8 10841 Washer 3/8”
4 2 43757 Bracket Channel
5 2 83106 U-bolt 3/8”x 5”
6 2 83107 U-bolt 3/8”x 5” with cross relief
1.
1.
2.
2.
3.
4.
3.
4.
5.
5.
6.
6.
Mounting for
2”Wx 3”H Frame
• Ideal for jon boats, bass boats and
personal watercraft
• Non marking high impact covers
• Hot dip galvanized steel tubing
• Fits over 2”W x 2H” & 2”Wx 3“H tubes
• 20” overall height
• Fits over 2” wide cross members
Installation Instructions
1. Using the bracket channel (4) and guide tube
(1) as a guide, check position on cross beam
or frame for product placement, the bracket
channel (4) can be placed in the up or
down position.
2. Place one straight u-bolt (5) and one cross
over u-bolt (6) over or under the frame. Make
sure the cross over u-bolt over laps the
straight u-bolt (see note below). Position
bracket channel (4) over/under the u-bolts.
Loosely attach washers (3) and nylock
nuts (2).
3. Inset a guide tube (1) into the bracket channel
(4) place both for final position.
4. Make sure the guide tube is properly seated
within the bracket channel, the cross relief
u-bolt rest over the straight u-bolt and the
guide tube mounts at a 90˚ angle to the frame.
5. Finish tightening the u-bolts.
NOTE: On 2”W x3”H tube the u-bolts are not
“Cross mountined”.
Instruction Sheet #08118
Mounting for
2”W x 2”H Crossmember