Tie Down 86060 - Manual

042110,A1113
TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
Heavy Duty 8-Lug Spare Tire Carrier
Instructions
Part #86060
Instruction Sheet #08124
Mounting Instructions
1. Using the spare tire carrier and spare tire as a
guide, determine a suitable mounting location on
trailer frame.
2. Slide Grade 5 hex head bolt and washer (not included)
through front (top) tire carrier, over the frame and
through the rear mounting bracket. Use the bolt
pattern that fits closest to the frame. Loosely mount
with Grade 5 nyloc nut (not provided), repeat for
bottom bolt/washer/nut.
3. Using the spare tire to determine the correct holes to
use, place the carriage bolts provided for mounting
the spare tire in the holes of the tire mounting plate.
Bolt heads should be on the back side of the tire
carrier. Secure bolts with “star” washers.
4. Check position of the tire mount for proper clearance
with the spare tire before tightening bolts.
5. Once position is determined tighten both mounting
bolts/nuts.
6. Mount spare tire and tighten lug nuts.
Must Purchase Separately:
Mounting Hardware Option One
2 - 5/8” Grade 5 Hex Head Bolts
{length determined by frame width}
2 - 5/8” Grade 5 Nyloc Nuts
4 - 5/8” Washers
Mounting Hardware Option Two
2 -5/8” Grade 5 Hex Head Bolts
{length determined by frame width}
2 - 5/8” Grade 5 Nuts
2 - 5/8“ Lock Washers
2 - 5/8” Washers
Star Washers
Bolts
Bolts &
Washers
Rear Mounting Plate
Nyloc Nuts
& Washers
Lug Nuts