Tie Down Vector Dynamics System with PVC Pipe Adapter - Manual (Page 2)

Longitudinal Stabilizer Devices
As an alternate to installing longitudinal anchors and stabilizer plates, the installer may use longitudinal
stabilizing devices approved by the state and/or manufacturer*, including Tie Down’s LSD (Longitudinal
Stabilization Device). The use of one LSD system per beam for a single section and two systems per section for
a multi-section replaces all longitudinal anchors, stabilizer plates and straps in Wind Zones I and II. Three
systems per section are required in Wind Zone III.
* Verify approval requirements with the regulator and the home manufacturer.
Part # Description
59271 LSD Pad - 3 Sq. Ft.
59026 LSD Hardware Kit
Includes- 2 tie brackets
2 beam clamps.
59016 Longitudinal Strut 30"
for use up to 18" high piers
(two block piers)
59012 Longitudinal Strut 39"
for use up to 24" high piers
(three block piers)
59013 Longitudinal Strut 44"
for use up to 32" high piers
(four block piers)
59014 Longitudinal Strut 53"
for use up to 40" high piers
(five block piers)
59015 Longitudinal Strut 65"
for use up to 48" high piers
(six block piers)
1. Longitudinal Foundation Pad
2. Beam Clamp (2 per system)
3. Longitudinal Strut
(2 per system)
4. Tie Bracket (2 per system)
Note: LSD pads provide
3 sq. ft. of bearing
support per system.
3
2
1
4
Wind Zone
I or II
Double Section
18 Ft. Max. 36 Ft. Max. 36 Ft. Max.
Examples of Possible Placement:
Wind Zone
I or II
Single Section
Wind Zone
III
Double Section
1. Determine where the Longitudinal Stabilizing Device
will be installed on the home.
2. Place one L2SD pad centered under the beam.
Note: Press pad into the ground so that the cleats
are below ground level.
3. Slide tie brackets into pad.
4. Build pier on L2SD pads between tie brackets.
5. Attach one strut to each tie bracket.
6. Install beam clamps on ether side of pier. Attach
L2SD struts to beam clamps and tighten all bolts.
Maximum angle (from horizontal) of strut is 45 degrees.
0
4
0
4
0
3
,1
3
0