Tii 96-00-1 SERIES - Manual

TII P/N: 92222101
141 Rodeo Drive tii 96-00-1 SERIES
Edgewood, NY 11717 ADSL POTS SPLITTER MODULE
Customer Service/Sales 888-844-4720 Rev B 07/09
INSTALLATION NOTE
1.0 DESCRIPTION
1.1 The TII 96-00-1 Series ADSL POTS Splitter Module
maintains a constant direct connection between
customer and central office service provider.
1.2 The Splitter Module is equipped with a customer test
jack (see Figure 1). The customer can insert the RJ-11
plug from a working telephone into this test jack to
assure a signal is received from the central office. This
is the only time the customer is disengaged (both DSL
and POTS service) from the central office.
2.0 WARRANTY
2.1 See TII Warranty. If this unit fails during the warranty
period, the factory should be requested to authorize return.
Return the unit prepaid when authorization is received.
Units that fail due to abuse or normal wear should be
discarded.
3.0 INSTALLATION
3.1 INSTALLING ADSL POTS SPLITTER MODULE
3.1.1
Remove the Splitter Module from plastic bag and
inspect; if damaged, replace with an undamaged Splitter
Module.
3.1.2 Hold the Splitter Module with the cover pivot side on
the right. Lower the pivot side edge inside the designated
installation cavity.
3.1.3 Engage the right end ledge under the catch. (See
Figure 2)
3.1.4 Push the left side end down until the latch snaps
closed.
3.2 SPLITTER MODULE WIRING
3.2.1
Five telephone voice (POTS) pairs and one DSL line
(DATA) can be connected to a single Splitter Module. The
customer has the option of installing a #10 Master lock around the
customer lock hasp (see Figure 1).
3.2.2 When installing the first pair of customer telephone wires,
always begin with the bottom terminating rockers (see Figure 1).
3.2.3 Do not strip wire insulation from wires to be
terminated to Splitter Module.
CAUTION: TO REDUCE THE RISK OF PERSONAL INJURY,
INSERT A RJ-11 PLUG INTO THE CUSTOMER TEST JACK
PRIOR TO MAKING ANY WIRING CONNECTIONS.
3.2.4
Dress terminating wires (to protector) over NID
divider.
3.2.5 Insert and terminate TIP (GRN) & RING (RED)
wires into sealed IDC station protector (see
protector installation note for further details).
3.2.6 Open customer security cover on Splitter Module.
3.2.7 Lift all Splitter Module rockers to the open
position as shown (see Figure 1).
RING SIDE (RED)
TIP SIDE (GREEN)
LEFT SIDE LEDGE
TIP (GRN) & RING (RED)
TERMINATING WIRES (TO
PROTECTOR)
Figure 2
Figure 1
CUSTOMER TEST JACK
VOICE CIRCUITS ONLY
TEST PORTS
DATA -DSL SIGNAL TO
MODEM
ALL IDC’S ACCEPT 22-26
AWG SOLID WIRE
PIVOT SIDE LEDGE
CUSTOMER LOCK HASP