Tii 169F SERIES - Manual

P/N 92234601 • Rev A• ECN 10-048 • 3/19/2010
Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.
Model 169F SERIES
Fiber Interface Device
Installation Note
Description
1. The TII 169F Fiber Optic Interface Device is a
compact fiber optic connectivity and fiber slack
storage enclosure.
2. The large split grommets located at the bottom
of the base allow Telco drop lines and
customer cables to enter and exit the device.
3. The TII 169F is supplied with SC adapters to
allow one to four fiber optic connections.
4. The slack tray allows for sufficient fiber cable
slack storage.
Features
Figure 1
Installation
1. Mount the 169F Device so as to minimize the
possibility of dirt or moisture getting into the
enclosure.
2. 169F Devices mounted side-by-side or end-to-
end should be placed so covers can easily be
opened.
3. Remove the slack tray from the enclosure to
expose the mounting screw locations.
4. Mount the 169F Device vertically on a flat
surface using appropriate hardware (the
length of the mounting screws should allow for
1/8” of length within the enclosure).
5. The mounting holes are covered with a thin
film of plastic, easily punched out, to maintain
the environmental integrity of the enclosure
(See Figure 2).
6. Re-install the slack tray into the enclosure and
prepare for wiring.
Figure 2
Mounting holes
Grommet
Wire Entry
Grommet
Wire Exit
Telco Entry
Grommet
Slack Tray
Fiber Optic
Interface Device
Enclosure
Customer Exit
Grommet
SC Adapter
Strain Relief for
FTTX Connector
SC Bulkhead