Tii 506F-03 - Manual

P/N 92235301 • Rev A• ECN 10-092 • 5/20/2010
Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.
Model 506F-03
Fiber Interface Device
Installation Note
Description
1. The TII 506F-03 Fiber Optic Interface Device
is a compact fiber optic connectivity and fiber
slack storage enclosure.
2. The large split grommets located at the bottom
of the base allow Telco drop lines and
customer fiber cables to enter and exit the
device.
3. The TII 506F-03 allows for sufficient drop/fiber
cable slack storage in the base enclosure as
well as an additional
1.5” tall slack tray that
holds an ample amount of customer fiber
cable slack.
Features
Figure 1
Installation
1. Mount the 506F Device so as to minimize the
possibility of dirt or moisture getting into the
enclosure.
2. 506F Devices mounted side-by-side or end-to-
end should be placed so covers can easily be
opened.
3. Mount the 506F Device vertically on a flat
surface using appropriate hardware (the
length of the mounting screws should allow for
1/8” of length within the enclosure).
4. The internal mounting holes are covered with
a thin film of plastic, which are easily punched
out, to maintain the environmental integrity of
the enclosure (See Figure 2).
5. In addition to the internal mounting holes
mentioned in step 4, there are external
mounting ears which are provided for exterior
mounting. Mount as previously stated using
the appropriate mounting hardware and
methods (See Figure 2).
6. You are now ready to place the drop/fiber
cable slack into the enclosure and prepare for
wiring.
Telco Entry
Grommet
1.5” Tall Slack
Tray
Customer Exit
Grommet
Strain Relief
Pad
Strain Relief for
FTTX Connector
Slack Retention
Fingers