Tii FET1 Series - Manual

P/N 92241801 • Rev B• ECN 14-091 • 4/7/2014
Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.
Model FET1 SERIES
Fiber Entry Terminal
Installation Note
Description
1. The TII FET1 Fiber Entry Terminal is a
compact fiber optic connectivity and fiber slack
storage enclosure.
2. The large split grommets located at the bottom
of the base allow Telco drop lines and
customer cables to enter and exit the device.
3. The TII FET1 is supplied with SC adapters to
allow one to two fiber optic connections.
4. The slack tray allows for sufficient fiber cable
slack storage.
Features
Figure 1
Installation
1. Mount the FET1 Device so as to minimize the
possibility of dirt or moisture getting into the
enclosure.
2. FET1 Devices mounted side-by-side or end-
to-end should be placed so covers can easily
be opened.
3. Remove the slack tray from the enclosure to
expose the mounting screw locations.
4. Mount the FET1 Device vertically on a flat
surface using appropriate hardware (the
length of the mounting screws should allow for
1/8” of length within the enclosure).
5. The mounting holes are covered with a thin
film of plastic, easily punched out, to maintain
the environmental integrity of the enclosure
(See Figure 2).
6. Re-install the slack tray into the enclosure and
prepare for wiring.
Figure 2
Mounting holes
Grommet
Wire Entry
Grommet
Wire Exit
Splice Chip
SC Bulkhead
Slack Tray
Strain Relief for
FTTX Cable
Telco Entry
Customer Exit
Grommet