Compaq S900 - Manual (Page 9)

E
nglish
8788
English - 7
English
♦♦♦
Recommended Use of the Monitor
When setting up and using the monitor, pay special attention to the following for
optimum performance:
• Do not use your monitor against a bright background or where sunlight or
other light sources will shine directly on the screen.
• The monitor should be placed just below eye level (10°-15°) for optimum
viewing.
• Set the monitor's brightness to match the ambient room light.
• For optimum focus, the contrast control should not be set to the maximum
level unless the input signal level is extremely low. Also, the brightness
control should be set to a point where the overall background area just
begins to disappear.
• Allow adequate ventilation around the monitor so that the heat from the
monitor can properly dissipate.
• Neither the monitor itself, nor any other heavy objects, should rest on the
power cord. Damage to the power cord can cause fire or electrical shock.
• Keep the monitor away from high-capacity transformers, electrical motors,
or other strong magnetic fields.
• Your monitor should not be used in damp, dusty, or dirty areas.
• Handle your monitor with care when transporting it.
Master Power Reset Switch
The black Master Power Reset switch on the left side of the back of the monitor is
installed for technician use when the monitor is being serviced. Be sure this switch
is turned on after you first install the monitor. Always leave this Power Reset switch
in the ON position. Do not use this switch to power on and power off the monitor.
Use the power switch on the front panel to power on and power off the monitor.
!
CAUTION
• Do not scratch or bump the surface of the CRT with a pen, a
screwdriver, etc.
• Clean the CRT surface with a lint-free, nonabrasive, soft cloth,
and do not use a solution or glass cleaner that contains abra-
sives, alcohol, or an alkaline solution such as ammonia.
I N T R O D U C T I O N