Tii 79 Series User Manual

Tii Equipment

Advertising
background image

TII P/N 92225101

141 Rodeo Drive

tii 78 / 79 Series

Edgewood, NY 11717

Dual Service Provider Switch

Customer Service/Sales 888-844-4720

02/08 Rev B

INSTALLATION

NOTE











1. GENERAL DESCRIPTION

1.1 The TII 78 and 79 Series are designed for
applications requiring more than one service provider
which requires a connection to a single tip-ring pair. It
offers one or more outputs for the customer premises
telephone wire termination.

2. WARRANTY

2.1 See TII Warranty. If this unit fails during the
warranty period, the factory should be requested to
authorize return. Return the unit prepaid. Units that fail
due to normal wear or abuse should be discarded.

3. INSTALLATION

3.1 Remove the Dual Service Provider Switch
from plastic bag and inspect; if damaged, replace with
an undamaged switch.
3.2 Installation is accomplished using standard
technician tools. The Insulation Displacement
Contacts (IDC) are achieved using gel sealed
rockers.
3.3 IDC Terminations accept 26-22 AWG solid wire.
3.4 Locate a suitable flat, dry area to install the unit.
Use a size #8 screw to mount the unit. Install the TII
78 Series Termination Block. See Figure 1.
3.5 The 78 switch can be installed within an indoor /
outdoor listed housing. Use suitable hardware to
attach the block to the mounting service.
3.6 The 79 switch mounts in the customer
compartment of a TII 5100 NID. See Figure 2.
3.7 Lower the 79 switch into the 5100 NID and align
the locating fingers with the locating slots. Press down
until unit locks into locking tab. See Figure 3.

4. WIRING

4.1 Provides three pair customer wire terminations
with very low insertion loss from input to output.




Do not strip wire insulation from wires to be
terminated to Switch.























NOTE: IDC’s accept 22-26 AWG solid wire. Wires
should be aligned to the corresponding holes.
Green wire to the “T” (GRN) labeled wire guide
and the Red wire to the “R” (RED) labeled wire
guide.





TII 78

FIGURE 1

Wire Loom

Test Points

Customer Wire Telco

Output Terminations

Digital Voice

Service Input

RJ-11 Interface

Tip (Green)

Ring (Red)

3 Pair Telco Input

MTA Input

Mounting Hole

TII 79

TII 78 Wiring

Advertising
This manual is related to the following products: