Tii 761S-2T - Manual

P/N 92228701 • Rev B• 3/6/2008
Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.
Model 761-2T/761S-2T
Indoor Telephone Surface Mount Phone Jack
Installation Note
Description
1. The tii 761-2T is an indoor telephone surface
mount phone jack with one RJ-11 jack and
one double IDC rocker.
2. The tii 761S-2T utilizes gel sealed insulation
displacement terminations that provide reliable
connectivity.
3. The tii 761-2 Series is for indoor use only.
4. IDC rockers are used to terminate 26-22 AWG
solid wire.
Installation
1. The 761-2 series should be mounted to a
standard single gang electrical wall box.
2. Locate the existing phone jack outlet box
where telephone wires enter the premises.
Disconnect the incoming telephone service to
the existing RJ-11.
3. Turn the 761-2 so the IDC rocker is facing you
(See Figure 1).
4. Pull up the bottom IDC rocker to the fully open
position, insert Telco wires as shown in Figure
1 until they bottom out, do not strip wires.
5. For Loop-Thru applications, insert premises
wiring to the top IDC as shown in Figure 1.
6. Push down the IDC rocker ’s to the closed
position for termination.
Figure 1
7. Dress the wires properly inside the junction
box and secure the 761-2 to the junction box
using the supplied #6 oval head screw’s (See
Figure 2).
1
2
3
1
Front / Rear Panel Features
1 Mounting Holes - Use supplied #6 oval head screws to fasten to electrical wall box.
2 RJ-11 Jack - Customer wiring interface.
3 IDC Rockers - Telco wiring interface.
3
Red Wire
Green Wire
Existing Junction Box
Telco
Wiring
Premises
Wiring