TL Audio VP-1 - Manual (Page 22)

driving, by limiting the maximum output level that the VP-1 generates. A
0VU output reading on the VP-1 should read approximately -18dB on a digital
recorder input (using +4dB connections) although this will vary with different
recorders. If the limiter threshold is set to approximately +17dB this would be
just below the point where the digital recorder may overload, so would be a
useful threshold to limit the output of the VP-1. Note that the ‘Limit’ LED is
active even when the limiter is in bypass mode, thus acting as a useful output
peak indicator.
6 SERVICE
Should the processor require service, it must be taken or posted to an authorised
dealer with a description of the fault. Please retain the original packing for possible
future use, and ensure the unit is suitably protected during transit. The manufacturer
cannot accept responsibility for damage caused during transportation. Proof of
purchase date must be included if claiming service under warranty.
The processor is supported by a limited warranty for a period of one year from the
date of purchase. During this period, any faults due to defective materials or
workmanship will be repaired free of charge. The warranty excludes damage caused
by deliberate or accidental misuse, tampering, operation on the incorrect mains
voltage, or without the correct type and value of fuse fitted. It is the user’s
responsibility to ensure fitness for purpose in any particular application. The warranty
is limited to the original purchase price of the equipment, and excludes any
consequential damage or loss.
Please record the following details, and retain proof of purchase:
Serial Number.............................
Date purchased...........................
Dealer.........................................