Toa WT-5100 - Manual (Page 4)

4
6. OPERATION
Step 1. Remove the battery cover and place the battery as shown below. (Ensure that the Power/
volume switch is set to the OFF position.)
Step 2. Replace the battery cover and securely lock it .
Step 3. Set the Channel selector switch to the same channel as the transmitter.
Step 4. Connect an optional earphone to the Earphone output terminal and put the earphone on
the ear.
Step 5. Switch on the power by turning the Power/volume switch clockwise, and adjust the volume.
The Operation/battery indicator either lights or flashes when the power is turned on.
Step 6. Turn off the power after use.
[State of the operation/battery indicator]
• Lighting state (indicates signal reception or standby)
Steadily lit: Receiving a signal
Flashing: Standby (no signal reception)
• Single color (indicates the state of battery capacity)
Green: Full capacity
Orange: Insufficient capacity
Red: Battery exhausted
• Dual color (indicates a setting error)
Red/green alternately flashing: Incorrect channel setting
[Battery replacement]
• A new LR6/AA alkaline battery will continuously operate the unit for about 15 hours. When the red
LED lights, replace the battery with a new one.
• The WB-2000 battery will continuously operate the unit for about 16 hours. When the red LED
lights, recharge the WB-2000.
EAR
CH
0
2
3
4
56
89
A
B
C
D
E F 1 OFF
PWR/VOL
Operation/battery indicator
7
Unlock the battery cover
to remove.
Place the battery.