Toa MB-WT4 - Manual

Please follow the instructions in this manual to obtain the optimum results from this unit.
We also recommend that you keep this manual handy for future reference.
MB-WT3
MB-WT4 RACK MOUNT BRACKET KIT
INSTRUCTION MANUAL
1. GENERAL DESCRIPTION
The MB-WT3 and MB-WT4 are dedicated Rack
Mount Bracket Kits for mounting equipment with
panel width of 210 mm into an EIA standard 19"
equipment rack.
The MB-WT3 is for single unit mounting and the MB-
WT4 for dual unit mounting.
2. COMPONENT PARTS
MB-WT3
MB-WT4
Stay Mounting Hardware
Machine screw M4 x 8 .............................. 1
Flat washer (for M4) .................................. 1
Machine screw M3 x 6 .............................. 1
Spring washer (for M3) .............................. 1
Flat washer (for M3) .................................. 1
Bracket Stopper Mounting Hardware
Machine screw M3 x 6 .............................. 1
Spring washer (for M3) .............................. 1
Flat washer (for M3) .................................. 1
Rack Mounting Hardware
Rack mounting screw 5 x 12 ..................... 4
Fiber washer (for M5) ................................ 4
Bracket Stopper Mounting Hardware
Machine screw M3 x 6 .............................. 2
Spring washer (for M3) .............................. 2
Flat washer (for M3) .................................. 2
Rack Mounting Hardware
Rack mounting screw 5 x 12 ..................... 4
Fiber washer (for M5) ................................ 4
Bracket A ...1
Bracket B ... 1
Stay ... 1
Bracket Stopper ... 1
Bracket ... 2
Bracket Stopper ... 2
Connector ... 1
3. MB-WT3 INSTALLATION
Step 1. Slide the Bracket A into the unit's guide rail
until it stops.
Guide rail
Bracket A
Note
Though this figure shows the
way to place the unit on the
left in a rack, the MB-WT3
permits the way to position
the unit on either side.
Step 2. Mount the Stay to the Bracket A.
Machine screw M4 x 8
Flat washer
(for M4)
Flat washer (for M3)
Spring washer (for M3)
Machine screw M3 x 6
Stay
Step 3. Slide the Bracket B into the unit's guide rail
until it stops.
Bracket B
Step 4. Secure the Bracket Stopper to the Bracket B.
Bracket Stopper
Flat washer (for M3)
Spring washer (for M3)
Machine screw M3 x 6